Vanity stool bench – Make a wooden pallet for your vanity as DIY. Vanity stool includes legs, seat and cross support. The pallet must be of hardwood like maple, oak or walnut. Specific details can be added to the podium as a decorative border at the bottom of the legs to add a more elegant touch to the design. Place 1 of the 14 by 18 inch boards on a flat surface with a 14 by 18 inch side of the flat on the work surface. These are the bones boards. Draw a concave decorative curve on a 14-inch wide end of each board. Use flexible ruler curve to accurately transfer curve for the second line.
In addition vanity stool bench, cut decorative curve on the band saw at the bottom of each leg on board. Then, sand down the legs with sandpaper until it is completely smooth. And then place the 1 by 6 by 22 inch board on a flat surface with the sixth by 22 inch flat side. And also draw a decorative border along a 22 inch edge of the board. Use flexible curve ruler to make symmetrical curves along the edge. This is the cross support for the podium.
12 Photos Gallery of: Making Vanity Stool Bench
Vanity stool bench, cut out the decorative edge along the 22 inch edge on the cross support with a band saw. Sand the edge with sandpaper until it is completely smooth. Placing the legs of a table located parallel to each other with bottoms resting flat on the work surface about 22 inches apart. And also place the cross support with decorative edge downward between the legs. The support should be in the middle of 14-inch width of the legs. And then the upper edge of the support should be flush with the upper ends of the legs.