How To Build Bed Platform With Drawers – Several drawers under a full-size bed, take advantage of and organizing more than 25 square feet of storage space. Although you hundreds on the frame of a prefabricated bed with drawers under bed can spend is building your own at half the cost the project well within the reach of most beginner and intermediate woodworkers. These plans are for a full – or double-size platform frame with drawers underneath, but you can build for any size mattress by adjusting the timber dimensions.
Use your power saw shortening store-bought plywood sheets to the required dimensions to build bed platform with drawers. Sand all faces of all timber twice, once with coarse grit sandpaper and once with fine-grit paper. A coat of paint applied to all surfaces of your timber. Let dry. Set all four 2 by 8 bars on the ground, parallel to each other and arranged with their goals. All four bars should rest on their narrowest, 2-inch, faces. Give the joists 33 inches apart, from edge to edge. Two of your 54-inch by 37 set half-inch plywood worksheets side by side on the top of the frame formed by the beams. Screw them in place with 16 wood screws, two screws evenly spaced sheet per bundle. Screws drive through the plywood and into the bar. Turn the frame so that it rests on the plywood. The remaining two 54-inches set with 37 1/2-inch plywood on the joists and attach just as you did the first two.
12 Photos Gallery of: How To Build Bed Platform With Drawers
To build bed platform with drawers use two 7 1/2 inch wide plywood boards, one 24 inches long and get one 33 inches long. Put them in L-shape with the shorter blade at the end against the longer. Nail them in place with three finishing nails. Repeat step one with two more sheets of plywood the same size, construction of a second L-shape. Connect the L-shape to form a rectangular frame, the walls of the tray. Use three finish nails every angle to attach them. Set the 25-inch by 33-inch plywood sheet on top of the frame. Connect to a nail in each corner, driven by the leaf and in the frame below. With two nails per side, evenly distribute to increase the angle between nails. Flip over the course of the tray. Attach a cabinet or drawer pull to the center of one 33-inch by 7 1/2-inch plywood sheet. Repeat steps one to five twice more, to build two more trays. If your bed are expose to both long ends will build a total of six drawers, three for each side. Slide the guide in the openings between the beams of the frame of the bed so that the tensile force is facing out.